Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Call pickup from analog phone connected to ATA devices

Is there some key stroke(s) (or whatever) one could enter on a analog phone connected to an ATA18? which has been assigned an IP number such as 3101 and that number 3101 is in the same call pickup group as a group of IP phones in order for that analog phone to pickup a call coming in on one of the IP phones (i.e. in the same call pickup group)?

1 REPLY
Gold

Re: Call pickup from analog phone connected to ATA devices

Check here for the procedure to execute Call Pickup and Group Call Pickup from an analog phone on an ATA-186 or ATA-188. It's basically **3 and then a hookflash.

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_administration_guide_chapter09186a008014c63c.html#25675

356
Views
5
Helpful
1
Replies