Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call Pickup on Analog Phones

Is there a way to configure Analog Phones to do Call pickup.They go to a HDA Module on a 2620 gateway and are registered with the Callmanager.We can configure them to be in the Callpickup group but Is there a way we can configure a feature code for them to pick up the call from these phones.

1 REPLY
New Member

Re: Call Pickup on Analog Phones

Not at this time with the NM-HDA.

You can use call pickup from an analog phone connected to an ATA-186. Cisco calls it pre-call features and with by dialing **3 you can perform a call pickup on a handset connected to a ATA-186.

There was some speculation awhile back that Cisco might add this capability to the vic-2fxo modules, but I've not heard anything direct from Cisco on it.

tm

Tim Medley, CCDP, CCNP

IPT Consultant

http://www.iptnetworkers.com

293
Views
0
Helpful
1
Replies
CreatePlease login to create content