Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

call rejected

What´s problem this call? They see:

.May 9 17:08:49.979: Sending Complete

.May 9 17:08:49.979: Bearer Capability i = 0x8090A3

.May 9 17:08:49.979: Channel ID i = 0xA98384

.May 9 17:08:49.979: Called Party Number i = 0x80, '1300', Unknown/Unkn

own

.May 9 17:08:50.015: ISDN Se1/0:15: RX <- CALL_PROC pd = 8 callref = 0x8761

.May 9 17:08:50.015: Channel ID i = 0xA18384

.May 9 17:08:50.023: ISDN Se1/0:15: RX <- ALERTING pd = 8 callref = 0x8761

.May 9 17:08:50.023: Channel ID i = 0xA18384

.May 9 17:08:50.023: Locking Shift to Codeset 5

.May 9 17:08:50.023: Codeset 5 IE 0x32 i = 0x80

.May 9 17:09:10.087: ISDN Se1/0:15: TX -> DISCONNECT pd = 8 callref = 0x0761

.May 9 17:09:10.087: Cause i = 0x8095 - Call rejected

.May 9 17:09:10.107: ISDN Se1/0:15: RX <- RELEASE pd = 8 callref = 0x8761

.May 9 17:09:10.111: Cause i = 0x809080 - Normal call clearing

.May 9 17:09:10.115: ISDN Se1/0:15: TX -> RELEASE_COMP pd = 8 callref = 0x076

1

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: call rejected

THe ISDN switch is rejecting the call but it does not say on what parameter. In my experience it could be they are expecting an ani for the call and they are not getting it.

4 REPLIES
Silver

Re: call rejected

THe ISDN switch is rejecting the call but it does not say on what parameter. In my experience it could be they are expecting an ani for the call and they are not getting it.

New Member

Re: call rejected

Exist a way in the router to interpreter this ANI or command relative to a tecnology ISDN?

New Member

Re: call rejected

What model gateway are you using? Is it CAT OS or IOS?

New Member

Re: call rejected

I´m using IOS for solutions.

510
Views
0
Helpful
4
Replies
CreatePlease to create content