Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

call routing

Hi,

I have a H323 voice gateway Vg200 with this following configue:

!

voice-port 1/1/1

input gain 14

output attenuation -6

description connection to PSTN

music-threshold -30

supervisory disconnect anytone

no battery-reversal

!

dial-peer voice 1000 voip

destination-pattern ...

progress_ind progress enable 8

max-redirects 10

session target ipv4:173.16.10.200

dtmf-relay h245-alphanumeric

when I call from PSTN :

PSTN call (( example telephonique N° 1234 ))>>> vg200 (( ring, the FXO cards hang up and lisen a dial tone )) >>> (( I compse the Directory number of the Ip Phone that I hope contact example DN 2020 )) >>> callmanager>>> IP Phone.

My probleme it's to eliminate the ring and the dial tone.

I wish dial the whole number to contact the ip phone :

PSTN call (( example call N° 12342020 ))>> vg200>>> callmanager>>> IP Phone.

thanks .

  • Other Collaboration Voice and Video Subjects
1 REPLY
Silver

Re: call routing

You need to have connection plar under your voice port.

connection plar 1234

When there is an incoming call on that port, the FXO will answer the call and then make a call to string 1234. You should have a VOIP dial peer for that number pointing to the call manager.

79
Views
0
Helpful
1
Replies
This widget could not be displayed.