Currenly have a CCM (3.1) connected to a Meridian Option 81c (X11 rlse 22.46)using Q931. Since upgrading from 3.08 we have lost the facility to transfer. A meridian user calls an IP phone which in turn transfers the call to either another IP phone or Meridian and the call will drop out, although it works fine with the softphone ver 1.2.1.
Which system is handling the transfer. CCM has to have two lines on a set to transfer. On the M1 Opt. 81C it is handled by a card in the core of the switch. I use to install 21e-81c and some SL100 switches it has been about 14 months since I have messed with one and moved over to VoIP with CCM.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...