Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

call transfer in CME

Hi;

I got one analog line which is connected to FXO port, and one IP phone 7960. I dial the line from outside and when I perform call transfer, with full-consult I hear the busy tone and with blind option,CME drops the call. what is solution?

thanks

Alex Goshtaei

1 REPLY
New Member

Re: call transfer in CME

You should post your config

but under telephony-service you could try:-

see if

transfer-pattern

is present, or CME will not allow transfer to non CME extensions. I've only seen the reverse of this but I don't have a working FXo to try it, mine blew up!

121
Views
0
Helpful
1
Replies
CreatePlease to create content