I have a Unity a system that was upgrade to version 2.4.6 when a subscriber forwards a VM to another subscriber by using the extension they do not hear the subscriber name. I would like to have the name played after punching in the ext. where you which to forward the VM.<br><br>
You can adjust this behavior system wide in the registry... it'll force Unity to always give name confirmation even if you just heard the name in the list you selected from (which some folks find annoying) but will also force name confirmation in Id addressing mode that you're talking about.
check out this post for details on how to do that:
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...