Caller ID (CLID) not being passed from SIP to ISDN
Hope you can help,
Does anyone know how to ensure that the Callser-ID gets carried from a SIP INVITE message over to a ISDN SETUP message ? From reading cisco papers, it appears that if the "remote-party-id" in the sip-message is populated, then the clid in the isdn-message should be automatically data-filled. But I have tried lots of configurations without any joy.
I am using an AS5350XM with 12.4-6.T3. I see the "remote-party-id" field correctly within the INVITE, but when I debug the ISDN-Q931, I see a blank field. It is not being passed on.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.