I have cell phone service with AT&T. The calls going to the cell phone displays "unknown" as the caller id. Whereas if I call a cell phone with cingular, verizon, or alltel service the caller id number is displayed on the cell phone. What is the difference? How do I correct this problem?
This is commonly seen when the number being passed to the telco is not an ISDN National Number, or the number is not a 10 digit number. Use the ISDN Q.931 translator that comes with CM to validate the numbering plan type and translate the digits at the gateway if neccesarry to send 10 digits to the PSTN.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.