12-04-2002 09:30 PM - edited 03-12-2019 09:49 PM
Hey There,
I finally swapped out the FXO WIC's to FXO-M1's so that we could get Caller-ID on our Lab system. Its not working!!! Arrg.
When there is a call in progress I can see the Caller-ID Info on the VG200 (both number and name!) but it doesn't get passed along to CM. I am using MCGP. Here is the config:
12.2.(11)T5 on a VG200
Building configuration...
Current configuration : 1265 bytes
!
version 12.2
no parser cache
no service pad
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname HDQ-VG1
!
enable secret 5 *************************
!
ip subnet-zero
!
!
!
voice call carrier capacity active
!
!
!
!
!
!
!
!
!
ccm-manager mgcp
!
!
interface FastEthernet0/0
ip address 192.168.1.10 255.255.255.0
no ip mroute-cache
duplex auto
speed auto
!
ip classless
ip route 0.0.0.0 0.0.0.0 192.168.1.1
no ip http server
ip pim bidir-enable
!
!
snmp-server community ******RO
snmp-server enable traps tty
call rsvp-sync
!
voice-port 1/0/0
input gain 8
caller-id enable
!
voice-port 1/0/1
input gain 8
caller-id enable
!
voice-port 1/1/0
input gain 8
caller-id enable
!
voice-port 1/1/1
input gain 8
caller-id enable
!
mgcp
mgcp call-agent 192.168.1.20 service-type mgcp version 0.1
!
mgcp profile default
!
dial-peer voice 1 pots
application mgcpapp
port 1/1/0
!
dial-peer voice 2 pots
application mgcpapp
port 1/1/1
!
dial-peer voice 3 pots
application mgcpapp
port 1/0/0
!
dial-peer voice 4 pots
application mgcpapp
port 1/0/1
!
!
line con 0
line aux 0
line vty 0 4
password ************
login
line vty 5 15
login
!
end
Is there something obvious? Whats the best way to troubleshoot this?
12-05-2002 02:35 PM
Not currently supported when running MGCP. The problem is all the call control signalling is backhauled to the CM when running MGCP, so the router doesn't know it has to look between the first and second rings for the caller ID information since the call control intelligence is on the Call Manager server..
Set up the gateway for H323 and it should work.
12-05-2002 02:43 PM
You can not do CLID with the FXO-M1 vic under MGCP mode. Not supported Revert to H.323 in order to do CLID.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: