Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Caller ID for transfers on CME

A customer with CME would like incoming calls answered at reception and then transferred, to show the original caller id on the destination phone when ringing and not the operator's phone number. Does anyone know of a way to acheive this in CME ?

Thanks,

Phil

3 REPLIES
Cisco Employee

Re: Caller ID for transfers on CME

The caller ID for original caller will show only when the transfered-to phone answers the call if you're using transfer-system full-consult. For the receptionist's ephone-dn, you may want to configure transfer-mode blind, so that the operator will perform blind transfers, which will cause the display to update immediately.

New Member

Re: Caller ID for transfers on CME

Thanks, but they would really like to keep full-consult to allow consult if required or for the operator to check for ring tone before pressing transfer to drop out of the call. At this stage it would be good if the display updated to show the original caller.

New Member

Re: Caller ID for transfers on CME

Looks like the local-consult option updates the display to show the original calling number but the full-consult option doesn't.

163
Views
4
Helpful
3
Replies
CreatePlease to create content