Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

caller id masking

Ok heres the scenario..i got 2 pri gateways running h323...I have about 200 did's and 200 non did's.

1st I am using the external mask on the phone so it displays 860701xxxx on each idividual phone...Thats seems to work ok...

Now on the non did's, should i put the main numbers external mask or is there anywhere that i can specify that if a phone doesnt have a external mask configured to use the main number?...If I specify the caller id on the gateway it overwrites the phones external mask

Thanks

Tony

1 REPLY
Silver

Re: caller id masking

Keep all the DID phones in one partition and a Route pattern in that partition to use one gateway. The Use External Phone mask should be enabled for this Route Pattern. The rest of the phones could use another Route pattern pointing to another gateway, where caller id would be configured with the Main number.

The following document will help you in configuration:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00800cde77.html

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00800cde76.html

91
Views
0
Helpful
1
Replies
CreatePlease to create content