Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

caller-id no working!! on VIC2-2FXO in china (124-24.T2)

at 124-24.T caller id is ok!!

but in 124-24.T2 caller id can't receive at phone.

cfg is the same:

!

voice-port 0/1/0

supervisory disconnect dualtone mid-call

cptone CN

timeouts interdigit 5

timeouts call-disconnect 5

timeouts wait-release 5

caller-id enable

!

try the all caller-id option,can't find the cause!!

caller-id alerting dsp-pre-alloc

caller-id alerting line-reversal

caller-id alerting pre-ring

caller-id alerting ring

at last I found the show voice port is different in 124-24.T and 124-24.T2,when the config is the same:

124-24.T:

Caller ID Info Follows:

Standard BELLCORE <<<

Caller ID is received after 1 ring(s)

124-24.T2:

Caller ID Info Follows:

Standard ETSI <<<xxxx

Caller ID is received after 1 ring(s)

how can I change Caller ID Info Follows:

Standard ETSI ? I already used the cptone CN !!

6 REPLIES
Hall of Fame Super Gold

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

Configure any european cptone and check again.

Or complain to cisco to have the problem fixed.

New Member

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

it seems a very strange bug. I have open case and help for tac.

Hall of Fame Super Gold

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

It happens all the time.

Cisco fixes something, but breaks something else.

New Member

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

but 124-24.T2 and 124-24.T are in the main version,in theory 124-24.T2 will only fix the old bug,but it seems bring the new bug.

Hall of Fame Super Gold

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

As mentioned above, new bugs are often introduced in the process of fixing existing ones.

New Member

Re: caller-id no working!! on VIC2-2FXO in china (124-24.T2)

TAC answer: to fix a ISDN PRI bug,124-24.T2 has to change Standard ETSI even

using cptone cn,suggest downgrade to 124-24.T,but  we are using ssl vpn,124

-24.T has the bug CSCtb73337,we have go to 124-24.T2 to fix CSCtb73337,can't

using caller id a long time.

--we and cisco TAC are crazying for these voice bugs and ssl bugs,it seems

too many bug in cisco voice and security!

866
Views
0
Helpful
6
Replies