Caller ID only shows inbound number on inside phone and all outbound calls only show the extension of the dialing station. Attempted prohibiting calling party presentation on MGCP gateway but had no success. Would like to restrict all outbound calls to a Caller ID DN but it does not seem to work either.
Not quite sure if I follow your question. Are you saying you want all outbound gateway calls to appear to the called party as one specific number? So...all calls outbound from any phone would show as 501-555-1212 on the caller ID of the called party?
You can change the External Phone Number mask per line from within the phone configuration/DN configuration screen.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...