Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller ID on VG200 T1 CAS

Can someone clarify whether or not I should expect

a T1 Vg200 gateway (CAS) to push calling party

information when I make an outbound call. Currently

when I make a call the called party doesn't get

any Caller ID information and I've verified with

the phone company that we are not blocking it.

Thanks

1 REPLY
Cisco Employee

Re: Caller ID on VG200 T1 CAS

Are you using E&M wink start? If so, that signaling method does not have any provisions for Caller ID services. Only the called number is sent via DTMF tones. E&M FGD can do this, but typically that is a signaling method used between telcos that cannot do ISDN with each other. But you could still ask for it.

73
Views
0
Helpful
1
Replies
CreatePlease login to create content