Have CCM 3.1.1 with 3600 Router as H.323 Gateway. BT present Caller ID on PRI interface without the leading 0 for STD access. E.G 012345.... comes in as 12345. We want to use the CLI to simply call back the original caller "Directory>Missed Call" sequence.
Translation Rule for incoming calls crahes the router with IOS 12.1(5)T
Any suggestions as to solution or alternate translation in CCM rather than the Router.
The translation pattern must be blank or match your extension range as this only looks at the Called number - I also suggest you use prefix digits and not a mask.
Even once you put the Translation pattern in place it will never be used because your extension numbers will always be more specfic and CM will route to those and not the pattern - this is why you must use partions and CSS to force the issue.
We already translate the Called Party number from the BT 6 digit presentation to 4 successfully for incoming calls, but we want tho translate the Calling Party also on incoming calls. This only seems possible on CM for modifying the outgoing CLI , which is why I was attempting to do it at the Voice port on the router using the Translation Rule. But the router just hangs after 2 rules are entered and outgoing calls placed.
The Translation Rule on the router will not accept a wildcard, so you have to say someing like (maybe not quite right, I'm now out of the office):
Rule 0 7.% 07 any unknown
and apply to the voice port.
This works for mobiles but then to cover the rest of the UK you need to add the prefixes for 01 and 02.
All sorted thanks. Transforms of course are based on the called party number, but allow you to change/prefix the calling party as you recommended. So just added the prefix to the existing called party transform and all works.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4