The incoming CLI from my carrier strips out the leading zero of the number so the number that appears on the phone is 1925 xxxxx not 01925 xxxxx and so you can't just hit the dial button on a 7960 when you have the list of received/missed calls on the display to call the number back.
Is there a way of putting the zero back in to the number automatically, or even inserting it back into the CLI on the incoming call?
I did have a translation pattern to do this but it clashed with other numbers in the dial plan.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.