In an AVVID set-up with VG200 MGCP gateway as PSTN back-up,is there
a specific way of setting an external phone number mask for this gateway on the CallManager by which caller ID can be sent to the person receiving our call.Or must this be configured in the gateway itself.
if you are using a pri connected to the gateway you can send almost anything if the telco allows that. if you have an fxo connection meaning you ordered pots lines from the telco you cant. the phone company sends the information based on what line the call is comming from just like in your house. i have neverf asked but the phone comany may be able to overide the actuall number with a main number that you have listed.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...