Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Caller ID with E1-R2

I have the following scheme:

Nec PBX - > E1-R2 - > Cisco 3620

How I can do so that when sees "sh call active voice brief", instead of appearing to me name of the port by where I enter the call appears the number of I telephone that it calls to me (caller ID)?

Regards

2 REPLIES

Re: Caller ID with E1-R2

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Caller ID with E1-R2

Hi,

You have to configure your Gateway to exchange Caller ID with The PBX by adding the following commands:

controller E1 2/0

ds0-group 1 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 1

unused-abcd 0 0 0 1

caller-digits xyz

dnis-digits min xyz max xyz

ani-digits min xyz max xyz

The ani key word is very important!

Regards

593
Views
0
Helpful
2
Replies
CreatePlease to create content