11-29-2001 03:52 AM - edited 03-12-2019 01:32 PM
I have the following scheme:
Nec PBX - > E1-R2 - > Cisco 3620
How I can do so that when sees "sh call active voice brief", instead of appearing to me name of the port by where I enter the call appears the number of I telephone that it calls to me (caller ID)?
Regards
12-09-2001 10:32 PM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
12-29-2001 04:02 AM
Hi,
You have to configure your Gateway to exchange Caller ID with The PBX by adding the following commands:
controller E1 2/0
ds0-group 1 timeslots 1-15,17-31 type r2-digital r2-compelled ani
cas-custom 1
unused-abcd 0 0 0 1
caller-digits xyz
dnis-digits min xyz max xyz
ani-digits min xyz max xyz
The ani key word is very important!
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide