Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller ID with fxo and Telluler

Hi every body ..

I have a uc500 with bulit in fxo ,,. i have connect to the FXO 0/1/0 an Ericsson Fixed Wirless terminal ... the ericson work like this ( you put a GSM SIM card on it -your mobile SIM for example- then you connect it to fxo port with your CME extention) so when any one dial your mobile number you get it in your ip phone.

one thing the Ericsson terminal can be set to use a multi CLIP standards : like DTMF,Bellcore,V.23

in my debug i use Bellcore

I will post this files:

1- uc500 running configuration

2-debugg VPM signal

Please help me if you can

1 REPLY
Bronze

Re: Caller ID with fxo and Telluler

FXO per definition can only receive caller-id, and FXS send it only. Check how your paging system expects to receive calling number, because it cannot be the caller-id method. Are you sure you are not using an FXS port ?

242
Views
0
Helpful
1
Replies