10-11-2010 01:54 AM - edited 03-13-2019 07:10 PM
Hi there. We have the following configured:-
- CUCM version 7.1
- Cisco IP Endpoint
- Cisco SIP Gateway
- Nortel CS1000M PBX
- Nortel Endpoint
- QSIG between Cisco SIP Gateway and Nortel CS1000M
when making calls betweent the Nortel endpoint and the Cisco Endpoints we don't get name displayed between the devices. Anyone know what is required for this to take place?
All help is hugely appreciated. :-)
Mark Cummings
10-11-2010 05:49 AM
On the VG, take "debug isdn q931" with "term mon".
Do not take any other debug for now. Do not use file attachments, just paste the output here.
10-11-2010 07:52 AM
Mark,
It typically best to use MGCP to integrate between a Nortel PBX, connected via QSIG ISDN T1, to a CUCM. This may be a limitation of tunneling QSIG over SIP to CUCM.
Is there a particular reason to that is causing you to use SIP?
Can you attach the running configuration and collect the following debugs.
debug ccsip message
debug voip ccapi inout
debug isdn q931
Please note the calling and called party numbers as well as the CLID name that should have been sent.
-Felipe
10-18-2010 02:37 AM
Hi everyone. Apologies for late reply...have been busy on priojects.
Many thnaks to everyone's replies adn sorry i did not get to read all, but I have found the resolution to this issue. FYI, please see a snapshot of relevant config on SIP Gateway as beliow:-
!
voice service voip
clid network-provided
qsig decode
address-hiding
allow-connections sip to sip
fax protocol pass-through g711alaw
sip
bind control source-interface Loopback0
bind media source-interface Loopback0
header-passing
asserted-id pai
!
interface Serial0/1/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-qsig
isdn timer T310 120000
isdn overlap-receiving
isdn protocol-emulate network
isdn incoming-voice voice
isdn supp-service name calling profile Network-Extension operation-value-tag local
isdn send-alerting
isdn sending-complete
isdn outgoing ie facility
isdn outgoing ie extended-facility
isdn outgoing display-ie
isdn outgoing ie caller-number
isdn outgoing ie called-number
trunk-group TG-2nd-QSIG-PAIR 1
no cdp enable
!
Theimportnat information in this case to make name passing work are the lines mentioning ie. Hope this helps others with same issues.
Many thnaks again.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: