04-10-2002 10:08 PM - edited 03-12-2019 03:04 PM
setup:
siemensA--1751---64K---1751--siemensB
VOIP end to end is ok. local phones on A can call B
and vice versa.
Problem:
when a phone on A calls a phone on B and vice versa
only the "calling number" appears on the display, instead of the name of the person assigned to that local.
04-17-2002 10:41 AM
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
04-17-2002 04:34 PM
What is your connection to the PBX's? I am guessing FXS or FXO. Does the PBX pass the calling name? Here is a URL on callerID-
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121newft/121t/121t3/clid_t4.htm
The FXO requires the M1 card to support callerID.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: