Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Calling Name Display changed direction

Lucent Definity G3 -> IP Phone Displays Calling Party IE while using 2600/ISDN-PRI gateway. IP Phone -> Lucent does not display Calling Party IE.

IP Phone -> Lucent Displays Calling Party IE while using DT-24+. Lucent -> IP Phone does not display Calling Party IE.

Was able to get both working using a 12.2 release, however forced to revert back to 12.1.3(XI6) due to other problems. DT-24+ works great except for this one issue. Lucent set up as national and user side. DT-24+ set up as network side. CCM 3.1

2 REPLIES

Re: Calling Name Display changed direction

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Calling Name Display changed direction

Hi, I am trying to set up something similar of what you have. I have a Definity G3 and a 3660 voice gateway. Right now I'm using an E1 with CAS but I'm not able to exchange names. The PBX does not have the software for PRI signalling.

Could you share the configuration of your PRI gateway? Any suggestion regarding the Lucent PBX will be appreciated as well.

Thank you,

120
Views
0
Helpful
2
Replies
CreatePlease to create content