Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Calling name on MGCP T1 CAS:

We are running ccm 5.1.3 and have an MGCP CAS T1 connected to another phone system. I would like to know if there is a way to present a predefined name on inbound calls from that T1 tie trunk. Currently we get unknown name when receiving a call. I know caller ID doesn't work but can I define a trunk group name to display so at least our users know what location is calling. We don't need the number at this point.

6 REPLIES

Re: Calling name on MGCP T1 CAS:

On the voice port you should be able to configure:

voice-port 0/0/0:0

station-id [name] | [number]

-nick

New Member

Re: Calling name on MGCP T1 CAS:

Thanks for the reply but it did not work for me. I don't see the station ID name or number when receiving a call. Does something need to be enable or disable to allow me to see it?

Re: Calling name on MGCP T1 CAS:

Sorry, for MGCP you would need to do this in CUCM.

It looks like in the Port configuration of the T1 you can specify a Caller ID DN. I would try putting the ID there, resetting the gateway, and seeing if this helps.

hth,

nick

New Member

Re: Calling name on MGCP T1 CAS:

Sorry, didn't work. I just put in a 5 digit number for the DN and it didn't come up. I did reset the gateway as suggested. Thank you.

Re: Calling name on MGCP T1 CAS:

It sounds like you won't be able to do this on T1 CAS. If you had a fgd-eana circuit you can receive ANI on that, however.

hth,

nick

New Member

Re: Calling name on MGCP T1 CAS:

Thanks for the reply but it did not work for me. I don't see the station ID name or number when receiving a call. Does something need to be enable or disable to allow me to see it?

294
Views
0
Helpful
6
Replies
CreatePlease to create content