Has anyone been able to get calling name to pass in both directions between a CM and an NEC 2400? Using QSIG I can get calling name to display on the Cisco phones (NEC to CM). Using NI2 I can get the name to display on the NEC phones (CM to NEC). CM is version 3.3(3).
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.