Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Calling router Initial a ISDN call ,but receive "SETUP" message

Config:

controller E1 0/3/0
framing NO-CRC4
pri-group timeslots 1-31

interface Serial0/3/0:15
no ip address
encapsulation hdlc
no logging event link-status
no snmp trap link-status
isdn switch-type primary-net5
isdn overlap-receiving
isdn protocol-emulate network
isdn incoming-voice voice
isdn send-alerting

voice-port 0/3/0:15

dial-peer voice 514 pots
destination-pattern 514.....
direct-inward-dial
port 0/3/0:15
forward-digits 8

The error message:

*Feb 24 01:35:34.041: ISDN Se0/3/0:15 Q931: Sending SETUP  callref = 0x01D1 callID = 0x8156 switch = primary-net5 interface = Network
*Feb 24 01:35:34.041: ISDN Se0/3/0:15 Q931: TX -> SETUP pd = 8  callref = 0x01D1
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech 
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98381
                Exclusive, Channel 1
        Called Party Number i = 0x80, '51466000'
                Plan:Unknown, Type:Unknown
*Feb 24 01:35:34.065: ISDN Se0/3/0:15 Q931: RX <- CALL_PROC pd = 8  callref = 0x81D1
        Channel ID i = 0xA98381
                Exclusive, Channel 1
*Feb 24 01:35:34.069: ISDN Se0/3/0:15 Q931: RX <- SETUP pd = 8  callref = 0x1D63
        Bearer Capability i = 0x8090A3
                Standard = CCITT
                Transfer Capability = Speech 
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA9839F
                Exclusive, Channel 31
        Called Party Number i = 0x80, '51466000'
                Plan:Unknown, Type:Unknown

1 REPLY
Hall of Fame Super Gold

Re: Calling router Initial a ISDN call ,but receive "SETUP" mess

You are connrcting to a PBX, such PBX is configured so that calls for 51466000 go out to router again.

So this is not a problerm with the router, and you have to fix the PBX.

300
Views
0
Helpful
1
Replies
CreatePlease to create content