I have this 2600 series router with E&M and FXO cards. E&M connected to our PBX system and the FXO card connected to PSTN. My questions is: Can it be possible to call the local line of the PBX by calling the PSTN line that is connected to the FXO port when you call from outside the branch? Thanks!
I assume what you mean is, if I called the PSTN line that your FXO port is connected to, can the 2600 make that call ring a number connected to the PBX through the E&M connection? If this is what you are asking, the answer is yes.
For example, if you want calls coming into the FXO port 1/0/0 to ring the PBX through the E&M card at extension 4000, then assuming you have already setup the proper dial-peers on the router to reach extension 4000, what I would configure is:
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.