I am trying to troubleshoot a CCM 3.3 implementation that was originally done by someone else. The problem is that when anyone calls in from the PSTN, the CallingPartyName always shows up as "Testing" on the phones. The number shows up correctly, but the name is always "Testing". I have looked at the gateway and there doesn't appear to be anything there. I have looked through the call manager itself and I cannot find anything there. I have also spoken with the PBX people and they say that the PBX is not capable of providing a name. So it appears that this is being added at the CallManager. Any ideas on where to look?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...