Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Callmanager 3.2(1) and IOS 12.2(7a)

Since i upgraded to 12.2 i can't make outgoing calls anymore. And imcoming calls are very noisy. Everything is fine with 12.0.XX.

This is some debug output from making a outgoing call.

*Mar 1 01:08:39: ISDN BR1/0: TX -> SETUP pd = 8 callref = 0x04

*Mar 1 01:08:39: Bearer Capability i = 0x8090A2

*Mar 1 01:08:39: Channel ID i = 0x83

*Mar 1 01:08:39: Display i = 'Lars'

*Mar 1 01:08:39: Calling Party Number i = 0x00, 0x81, '60', Plan:Unknown, Type:Unknown

*Mar 1 01:08:39: Called Party Number i = 0x80, '31', Plan:Unknown, Type:Unknown

*Mar 1 01:08:39: ISDN BR1/0: RX <- SETUP_ACK pd = 8 callref = 0x84

*Mar 1 01:08:39: Channel ID i = 0x89

*Mar 1 01:08:39: ISDN BR1/0: RX <- CALL_PROC pd = 8 callref = 0x84

*Mar 1 01:08:39: ISDN BR1/0: RX <- DISCONNECT pd = 8 callref = 0x84

*Mar 1 01:08:39: Cause i = 0x81D8 - Incompatible destination

*Mar 1 01:08:39: Facility i = 0x91A11302020344020122300AA1053003020100820101

*Mar 1 01:08:39: - ETSI Supplementary Service, Invoke, AOC-D Charging Units: 0

*Mar 1 01:08:39: BRI1/0:1: AOC-D Recorded Units = 0

*Mar 1 01:08:39: ISDN BR1/0: TX -> RELEASE pd = 8 callref = 0x04

*Mar 1 01:08:39: Cause i = 0x80E408 - Invalid information element contents

*Mar 1 01:08:39: ISDN BR1/0: RX <- RELEASE_COMP pd = 8 callref = 0x84

As you can see, the router is using the wrong baerer capabilty. Does some have a idea what could be wrong?

interface BRI1/0

no ip address

isdn switch-type basic-net3

isdn overlap-receiving

isdn incoming-voice voice

isdn send-alerting

!

voice-port 1/0/0

cptone DE

bearer-cap Speech

!

dial-peer voice 4000 voip

destination-pattern ..

session target ipv4:192.168.2.99

codec g711ulaw

no vad

!

dial-peer voice 1 pots

destination-pattern .

direct-inward-dial

port 1/0/0

!

2 REPLIES
Cisco Employee

Re: Callmanager 3.2(1) and IOS 12.2(7a)

Try doing:

config t

voice-port 1/0/0

 compand-type a-law

New Member

Re: Callmanager 3.2(1) and IOS 12.2(7a)

Ok! I was searching a whole week. Now it is working!

Thanks!

Cu

146
Views
0
Helpful
2
Replies
CreatePlease login to create content