I am trying to install CalManager 3.2(2c) (part number SW-CCM-3.2-CPQ=) on a Compaq DL320 (1133Mhz, 1152Mb RAM, 40GB HDD), but the installation does not go beyind the first hardware detection CD... The server does not boot from the CD (it boots other bootable CDs).. any help is appreciated.. The hardware is identical to the Cisco compatible list
We had this same issue with a DL-360 which we were configuring to be a counterpart to the 7835. Upon reading further I found some fine print on the compatability list:
1Unless otherwise specified in this document, all further references to the MCS-7835 apply to the MCS-7835, which contains a 733-MHz processor, the MCS-7835-1000, which contains a 1-GHz processor, and the customer-provided DL380.
2The same Cisco-approved hardware configuration standards apply for both the MCS-7835-1000 and the customer-provided Compaq DL380.
3All references to the MCS-7825 in this document apply to the MCS-7825-800, which contains a 800-MHz processor, and the customer-provided Compaq DL320. The same Cisco-approved hardware configuration standards apply for both the MCS-7825-800 and the customer-provided Compaq DL320.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.