Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CallManager 4.0(3) SIP trunk to Broadsoft VoIP platform

Can anyone explain the physical connectivity required for this configuration?

What equipment in the Broadsoft VoIP platform are we connecting the SIP trunk to?

Tasked with sorting this out, not looking for an easy out, just haven't found a clear answer to my questions in the docs.

Thanks.

1 REPLY
Anonymous
N/A

Re: CallManager 4.0(3) SIP trunk to Broadsoft VoIP platform

Use the Basic SIP Configuration for configuring SIP on your device

http://www.cisco.com/en/US/products/ps6441/prod_troubleshooting_guide09186a00803e5d12.html

PRI should be configured in the below mentioned method.

!

controller T1 1/0

framing esf

linecode b8zs

pri-group timeslots 1-24

!

interface Serial1/0:23

no ip address

isdn switch-type primary-ni

isdn incoming-voice voice

320
Views
0
Helpful
1
Replies
CreatePlease login to create content