CallManager 4.1(3)sr3b doesn't understand a specific H.225 cause id
we have a costumer running CCM 4.1(3)sr3b with an 2811 voice gateway (c2800nm-advipservicesk9-mz.123-14.T7.bin). When they dial a mobile phone number that is disconnected from GSM network and with no forward to voice mail, the voice gateway receives from telco in the RELEASE_COMP message a "Cause i = 0x8294 - Subscriber absent" that is passed to Callmanager in a RELEASE_COMP message as "Cause i = 0x8094 - Subscriber absent". So far so good. The problem is that the ip phone user that place the outgoing call doesn't hear any disconnected signal. The call simply "disappears" from the phone. Any ideas?
attached disl-peer configs and an output from a ccm trace.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...