Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Callmanager and MGCP 3660

I have configured both Callmanager 3.0(9) and Cisco 3660 with IOS 12.2.2(XA) for MGCP gateway. The gateway can see the callmanager and also the callmanager can see the router. I have also configured the route pattern of 9.@. When I dial 9, I don't get a dial tone, but if I continue, it looks like the phone dials the line, it rings then a busy signal. When I monitor the line (PSTN) that I am calling, it actually doesn't ring. When the line connected to FXO rings, The IP phone also rings. But when I pick it up. I get a busy signal.

Are there settings that I have should know?

Thanks.

Riann

1 REPLY
New Member

Re: Callmanager and MGCP 3660

It now calls the other end of the line. But still there is no dial tone after I dial 9. When the other line answers the phone, the call is disconnected.

86
Views
0
Helpful
1
Replies