Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CallManager and Siemens/Rolm Migration

I have a client with an existing Rolm and Aspect. We are building a complete IPCC network. The admin’s are using the Rolm that will stay in use long after the Aspect is replaced with IPCC so CallManager must be tied into the Rolm so admin users can call users in the call center. Does anyone have some insight on the process to migrate a Rolm to CallManager? I can't find any documenataion on CCO. Here is the Rolm version: 2 cabinet 9751 Model 10 Release 9005.6.84.

Regards,

-Ken

7 REPLIES
Cisco Employee

Re: CallManager and Siemens/Rolm Migration

What type of voice interfaces does the rolm have. T1-CAS or T1-PRI? That would be a good place to start.

Thank you,

-Mckee

New Member

Re: CallManager and Siemens/Rolm Migration

The Rolm currently has T1-CAS ports. What are my options?

-Ken

New Member

Re: CallManager and Siemens/Rolm Migration

IPCC should have papers on the aspect and Siemens, if you remove the aspect you will need ACD software in the Siemens I believe, if you have specific questions, about the Siemens send me an email.

A link for the aspect

http://www.cisco.com/univercd/cc/td/doc/product/icm/acdsup/aspctacd.pdf

jwise@wavenet.cc

New Member

Re: CallManager and Siemens/Rolm Migration

Thanks for the aspect link but I'm specifically looking for anything that states this very old Rolm 9751 system will tie into a CCM voice gateway with a T1-CaS configuration. I've found several doc's on the Rolm HICOM migration but nothing regarding this old Rolm 9751 PBX.

-Ken

Cisco Employee

Re: CallManager and Siemens/Rolm Migration

If all you are asking about is being able to call between one system and another (i.e. no IPCC or voicemail integration) then I don't see a problem here. We have a number of gateways that can handle T1 CAS signaling, we just need to know how the Rolm will be operating in that regard -- for instance, wink-start, immediate-start, fxo emulation, etc. -- so that you can choose the correct gateway accordingly.

New Member

Re: CallManager and Siemens/Rolm Migration

Thanks for the input. I am stuck with the WS-X6608-T1 gateway for this project. I was able to find that this gateway does support T1-CAS with CM 3.1. What type of "limitations" can be expected with a T1-CAS configuration?

-Ken

New Member

Re: CallManager and Siemens/Rolm Migration

what is the software of the 9751, 900X.X the system could have the latest software then it would be the same as a hicom switch.

jwise@wavenet.cc

260
Views
0
Helpful
7
Replies
CreatePlease to create content