03-16-2004 01:44 AM - edited 03-13-2019 04:17 AM
Hi @ all,
my situation: I have a avaya G3r connecting to a 3640 Voice Gateway via a pri. I am running CM 3.2(2c). When an IP phone calls a phone hanging off the avaya the caller ID shows the persons name. When an Avaya phone calls an ip phone the ip phone just shows the extension not the name.
I have done a q931 trace on the gw, the avaya sent the caller name. But the ip phone shows only the extension.
Any Idea's
regards, chris
03-22-2004 09:37 AM
Check the below link for interoperability between CCM and Avaya Definity.
03-22-2004 04:28 PM
Definately good to go through the PDF, also verify you have "Display IE Delivery" checked in your CallManager PRI configuration. This is if you are configured for 4ess or 5ess. If you are configured for NI, you should set yourself up as the Network side cuz NI doesn't support sending Name from user to Network. Lastly, if you are using QSIG, you will need to check the box that says Send Caller Name in Facility IE in your CM PRI setup.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide