Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CallManager Express 3.1 and Auto Attendant

CallManager express 3.1, IOS 12.3(7) T

AutoAttendant TCL script 2.0.1.0

Problem:

Outside caller from PSTN does not hear

progress ring when AA transfers to Operator or

Local Number. The call is completed though when operator or local picks up the call.

Does anybody have solution.

  • Other Collaboration Voice and Video Subjects
8 REPLIES
New Member

Re: CallManager Express 3.1 and Auto Attendant

You might want to try this to see if it resolves your issue. I do not know if you tried it or not.

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_tech_note09186a0080094c33.shtml#calmngr

HTH

Brian

New Member

Re: CallManager Express 3.1 and Auto Attendant

Brian,

Tried that but does not seem to work.

I dont think problem is with the gateway not

sending Ring back tone. I disabled AA on the router

and placed "plars" on the voice ports, PSTN users

can hear ring back on this config. I can also

remember this AA to work with a IOS ver 12.2(4)T it

only broke on 12.2(7)T.

I was trying to look for cme-aa-2.0.2.0.tar, this

was version of AA suppose to be for CME 3.1 but software center does not have it. So I settled with

cme-aa-2.0.1.0.tar which apparently does not work,

New Member

Re: CallManager Express 3.1 and Auto Attendant

I have 12.2(15)ZJ3 and running IP/FW/IDS PLUS IPSEC 3DES and you do not hear anything at all, it just kicks you out to the default destination that I have configured, our main HQ#.

So far I have no work around so I had to switch to usingthe AA inside CUE.

New Member

Re: CallManager Express 3.1 and Auto Attendant

CUE is a better way to go for AA. With Rel 1.1, we now also have the scripting tool to allow folks to create their own AA call flows. In addition, the AIM form factor also just got released. Sarat

New Member

Re: CallManager Express 3.1 and Auto Attendant

Is the scripting tool on the software download page so that I can download it? or do I have to purchase IPCC Express CRA application to recieve it?

Thanks!

New Member

Re: CallManager Express 3.1 and Auto Attendant

I found it and have it installed already.

Thanks!

New Member

Re: CallManager Express 3.1 and Auto Attendant

Hi.

Yes, I came out that problem in several IOS releases. Since the TCL script uses handoff to the dafault application. I don´t know the way to tell the default application to give a ringback tone.

I use a "workaround" modifying the TCL script and playing a call tone (it is no ringback, but the caller hear a sort of private tone). You should include the tone before handingoff the call:

set dest $oprtr

playtone leg_incoming tn_addrack

handoff callappl leg_incoming default "DESTINATION=$dest"

Is there an IOS way to activate the line tones in default app?

Before the script used directly:

"leg setup $dest callInfo leg_incoming"

so the control remained in the main script and the tone was given.

Miguel.

New Member

Re: CallManager Express 3.1 and Auto Attendant

Hello Miguel,

This is good workaround. I tried it and it works.

164
Views
0
Helpful
8
Replies