Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CallManager Express and Conferencing

Setup:

CallManager Express 3.0

ATA-186

Is conferencing supported on ATA-186s using

CallManager Express ?

Tried using the procedure on this link but it does not work.

http://www.cisco.com/en/US/partner/products/hw/gatecont/ps514/products_administration_guide_chapter09186a00801e0e10.html#1014773

I can only do transfers with the ATAs.

Using 7960s and 7910s conferencing works.

4 REPLIES
Silver

Re: CallManager Express and Conferencing

You chould have IOS ver 12.2(15)ZJ3. Only 3 persons can be in a conference, the number of conferences is platform dependent.

No, MeetMe is not supported.

Not Sure about ATA 186

New Member

Re: CallManager Express and Conferencing

Not sure what you are asking. Are you asking whether ATAs can be participants in a conference, or are you asking whether an ATA can intiate a conference? I think it is the second option. What do you get when you attempt this operation? I will check with the engineering team on this as well and come back with an answer here. Sarat

New Member

Re: CallManager Express and Conferencing

I want ATA to initiate a conference.

The ATA manual says to initiate conference, do a "hook Flash" then press "3".

When I press 3 I get busy signal.

New Member

Re: CallManager Express and Conferencing

Just got confirmation that a fix for this issue has been put into 12.3.7T due out first week of March.

Regards

Sarat

112
Views
0
Helpful
4
Replies