Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Callmanager G711a-law for ip phones

I would need to change codec G711u-law to G711a-law for ip phone communications. Where can i change it?

Thanks, Martin

3 REPLIES
New Member

Re: Callmanager G711a-law for ip phones

change your codec in your dial-peer voice from g711u to g711a, using the "codec g711alaw" cmmnd

thanx.

seanwy.

New Member

Re: Callmanager G711a-law for ip phones

if i change it on dial-peer, it does g711a between gw and ip phones.

I'd like to have g711a between ip phones and ip phones not between ip phones and gateway. Here it does g711u.

Martin

New Member

Re: Callmanager G711a-law for ip phones

Why would you want to change it? There is no need to change anything in IP phones. They will automatically adapt to correct codec based on the incoming call.

298
Views
4
Helpful
3
Replies
CreatePlease to create content