Re: Callmanager: High memory use after failover/failback
The way system is designed is once the memory allocated it will not be deleted but will be reused again for other calls or registration. So in reality there is no leak. If the it failsover again does it again increment by 300MG or stays at 600. Here is a lab test..
ccm.exe 43,652K(without Phones Registered)
ccm.exe 110,668k(with 250 Phones Registered)
ccm.exe 124,696k(with 250 Phones Registered and making calls)
ccm.exe 124,696k(with 250 Phones Registered and stopped calls)
ccm.exe 124,740k(Unregistered and deleted 250 Phones ) waited for 12
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...