I do not have a link but setting up a plar is very easy. for a given partition weather it is for auto registered phones or just a full time plar like a house phone or some thing like that. after you have created the partition for the plar add a tranlation pattern. leave the translation pattern blank set the parftition to the one that you jsut created. set the call search space to one that can call the phone the will be the other end of the ring down. finally change the called party transformation mask the the number of the device that will be called by the ring down. now any device that is in the new partition or devices that have a call search space with the new partition listed as the highest priority will call the number setup in the called party transformation mask of the translation patteren you just created when ever it goes off hook.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...