Hi, I've developed an phone service for use on the Cisco phones. It worked fine on the Phone Services Emulator) PSE. The next step for me is to run it on an actual phone, and since we don't have a CallManager instance, I'm trying to use the CallManager Simulator incluced in the Cisco IP Phone Services SDK4.1.1.
The phone get's its ip adress, but the moment it attempts connection with the Simulator, it reboots. I was able to get it to not reboot by delaying the startup of the Simulator until about a minute or so after the phone attempts the connection, then it starts the registering process (says registering on the phone as well as on the Simulator).
This is where it stops, never to budge an inch. I would appreciate any help in getting this to work.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...