The actual Callamanager(2pub and 2 Sub) is running on an old Hardware. We puchased new servers to install the CCM 4.1(3). Question is How to Upgrade and keep all Config of CCM 4.0(2)(phones,users...etc). Will it go like this:
1- Install CCM 4.0(2) on the New Servers
2- Run BARS Restore (assuming a Backup of CCM 4.0(2) is already taken of the old Hardware)
3- Upgrade Callmanager to 4.1(3)
Am i missing something? how about service releases...etc?
The DOc i found on Cisco is only relating to an Upgrade without Hardware Change.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...