Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CallManager with H323 Proxy

Hi,

I have the following situation

7960 --> CM1 --> GK1 <--> GK2 <-- CM2 <-- ATA186

I want to set proxy h323 on both gatekeepers. I do not want the 7960 to speak directly with the ATA186 after the call admission. But the problem is that after registering the both call managers in their gatekeepers, both the ATA186 and the 7960 could ring each other, which is normal because the both CMs are registered, but being not registered with the gatekeeper they could not speak directly with it, and the call drops on the third second. I do not find any way, as I read all the forums and the cisco website. It would be wonderful if the CallManager could acts like a proxy itself for the devices behind it.

I will appreciate if someone give me an advice how to make the end terminals aka ATA186 and the 7960 phone to speak only with their gatekeeper only.

I also have an international partner which accepts voices from only one IP address so I should proxy all the voices behind a gatekeeper, but tell me how can make the phones behind the CallManager to be proxied ?

Regards

2 REPLIES
Bronze

Re: CallManager with H323 Proxy

The following links have information on Proxy H323 GK.

Cisco ATA 186 Fails to Place a Call in a Gatekeeper Based Network

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_problem_troubleshooting09186a00800e654c.shtml

Troubleshooting Gatekeeper Endpoint Call Admission Issues

http://www.cisco.com/en/US/tech/tk652/tk701/technologies_problem_troubleshooting09186a00800e654c.shtml

New Member

Re: CallManager with H323 Proxy

I did not find anything useful in the above links that answer my question!

Any other ideas ? Does anybody have an idea if proxy h323 is supported in the new 3.3 Callmanager ?

100
Views
0
Helpful
2
Replies
CreatePlease login to create content