Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CallManger, Unity, W2k, DST and TZEdit.exe

I have CallManger 4.0 and Unity 4.0 both on W2k servers. I'm sure the answer is another conversation somewhere, but buried so here it is again.

Since the boxes are w2k can I just use the TZEdit tool from Microsoft to adjust the DST dates without any additional patching or negative concequences?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CallManger, Unity, W2k, DST and TZEdit.exe

Although it might work, I would recommend following the Cisco guidelines for updating these boxes for the sake of stability and TAC support.

Unity and DST

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps2237/products_field_notice09186a00807dcf40.shtml

Callmanager and DST

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_field_notice09186a00807e02b1.shtml

Hope this helps. If so, please rate the post.

Brandon

1 REPLY

Re: CallManger, Unity, W2k, DST and TZEdit.exe

Although it might work, I would recommend following the Cisco guidelines for updating these boxes for the sake of stability and TAC support.

Unity and DST

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps2237/products_field_notice09186a00807dcf40.shtml

Callmanager and DST

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_field_notice09186a00807e02b1.shtml

Hope this helps. If so, please rate the post.

Brandon

143
Views
4
Helpful
1
Replies
CreatePlease to create content