Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started.

Bronze

calls to CME are dropped

I have back-to-back PRI setup.

CM3.3 - GW(user side PRI) - CME4(acting as network side PRI).

When calling to CME, CME drops the call and does not ring the phone that is registered to it. ISDN code Cause i = 0x8290 - Normal call clearing . Interesting thing is that in debugs called number is not displayed, only calling number.

Also, I can't dial from CME to CM3.3. CM3.3 trace gives this 'ERROR Incoming H225Setup, could not find H225D pid for incoming H225Setup' and Cause i = 0x8095 - Call rejected.

Am I missing anything in config?

CME side:

voice rtp send-recv

interface Serial1/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn protocol-emulate network

isdn incoming-voice voice

isdn outgoing display-ie

no cdp enable

GW side:

voice rtp send-recv

interface Serial0/0:23

no ip address

no logging event link-status

isdn switch-type primary-ni

isdn incoming-voice voice

no cdp enable

  • Other Collaboration Voice and Video Subjects
182
Views
0
Helpful
0
Replies