I am having a problem with getting my 1760V w/8FXS-DID's to behave how I want them to. 2 issues:
1. I can't seem to find a way to group voice ports somehow so I can add simple dial-peers that take an inbound call and route it to the first open/idle voice port. Is this possible? I found the trunk group command, but ti seems to have more to do with gatekeeper auth then local call routing.
2. When I make an inbound pots dial-peer on a fxs port it won't do outbound (fxs) operation it seems anymore. Is the port only going to act uni-directionally?
ANy ideas would be appreciated, (or maybe a link to somewhere I may have missed searching).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...