Can I setup a VWIC-1MFT-E1 in cisco 1760 to use for voice ?
Im trying to setup a VWIC-1MFT-E1 1-Port RJ-48 Multiflex Trunk - E1 inserted in slot 0/0 from a cisco 1760 modular access router. But when I type the command "pri-group timeslots 1-31" It show me the error mesage "%Controller tdm clock does not have data capability". The router has the IOS image "c1700-sv3y-mz.122-4.YB.bin". I want to connect to PSTN through E1 connection.
Following that,I try to change the tdm clock source using this command "tdm clock E1 0/0 both export line".It show me the error mesage "%E1 data switching is not available in this configuration". If anybody know how to do, please help me..
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...