Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I share DSP from a NM-HD-2V module ?

Hi,

Can I share DSP from a NM-HD-2V module ?

My router is Cisco 2811 with one PVDM2-16 , VWIC-1MFT-G703 in HWIC slot 0 ,

NM-HD-2V and VIC2- 4FXO in NM slot1, and I need 20 voice channel G.711 for

VWIC-1MFT-G703 . In the DSP calculator the optimized result is one PVDM2-16+one PVDM2-8.

I don't use the VIC2- 4FXO module simultaneous with VWIC-1MFT-G703 module. The

NM-HD-2V module came with 8-channel voice with one DSP on board .Can I share DSP

from a NM-HD-2V module ? Can anybody help me with answers and config if its possible ?

Thanks Adrian

1 REPLY

Re: Can I share DSP from a NM-HD-2V module ?

There is a feature called DSP resource sharing for the ISRs and NM-HDV2. I am not sure if it will work with the NM-HD-2Vs

428
Views
0
Helpful
1
Replies