Can IP Phone & VMPS user coexist at the same switch port ?

[kshalavin]

Can IP Phone and a user with dynamically configured VLAN (VMPS) coexist at the same switch port ?

Typically, configuration with IP phone and statically configured user VLAN looks like:

interface FastEthernet0/1

switchport trunk native vlan 111

switchport trunk encapsulation dot1q

switchport mode trunk

switchport voice vlan 222

spanning-tree portfast

Is there any hints to put user into dynamic VLAN without changing voice vlan configuration ?

Thanks.

[pradeepde]

I think that the following link answers your question http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_guide_chapter09186a0080

0e46f5.html

[kshalavin]

Yes, I've read this document. It is suitable for CatOS switch version, and nothing noticed for switches with native IOS.